Exhaust tip set-up

Ok I think I'm finally going to get an exhaust... just need help deciding whether I want to do dual angle cut 4" tips out the back?

like so (yes I know those are bigger than 4" but I like the angles of it


or do a single 4-4.5" round cut tip right before the rear tire

like so


OR just dump it? I'm leaning towards the single tip before the rear tire

also what exhaust would you do? I don't need to be loudest truck around, but I do want something nice and throaty.. also looking to only spend $200? I don't know anything about exhausts so am I way under on the price? considering selling my old go-rhino steps to get a little more money for the exhaust. Also the tips will be black no madder the set-up

 

i just cut my side exit before the rear tire off. if you dont decide to get a body lift it would look good otherwise it looks like ****.

 

not getting a body lift

 

they are all about the same in price my second cousin says magnaflow is the best for our trucks, he owns a muffler exhaust shop

 

I had a 14" magnaflow on my truck before I straight piped it and it was barely louder than stock Decent rumble under accleration, but you could barely tell I had aftermarket pipes.

 

then doooo it! i think single side exit looks better than a dual.

 

Single side exit with 3 inch mandrel piping, cut out your two big cats (leave little cats), borla pro xs or borla xr1, and a 4 inch black tip

Sent from my SCH-I500 using Tapatalk

 

^yeah, after the Y-pipe do 3in all the way back and do a magnaflow or borla then tip it just after the muffler or pipe it after the axle and dump it.

 

BORLAAAAAAAAAAAAAAAAAAAAAAAAAAAAaaa