Has anyone, with a '10, had any issues with the factory remote start after installing LEDs inside? I have a '10 FX2 SCREW. I can do the rear dome and rear reading lights with no issue, however if I do the front map lights I get the 3x chirps when I try to remote start the truck. As soon as I pop them out... it works again. I've already reprogrmed the starter to remain running when I open the doors (Mykey crud) so that is not the issue. Is it a current draw issue? How would I correct this without simply puttingthe old bulbs back in (Which I have done). Any ideas?
^ what u need to do is use a resistor with the lights to make the computer think they are the stock lights. The leds draw less power than the halogen bulbs. The resistor would correct this. I don't know which one you would need tho. There cheap so u could pick up a few different ones and try em out til it works correctly.
