SHO-ME Model 11.1005SF.HD 6 amps per output, 2 outputs blue and yellow. I mounted the strobe power box in the driver's kick panel area and two switches up to the dash. One for power and the other a momentary switch for cycling the different strobe modes. Found these Blazer parking / turn signal LED for $19.99. Connected using butt connectors with crimp tool. Connecting ground to SHO-ME wiring harness that I ran from front of truck on frame rail to rear bumper. White to ground, Red to SHO-ME output wire. Black wire is for parking light, not used. I may connect this to the front turn signal later just to see what it looks like with LED strobe box off. Cut to length wire loom to cover exposed wires. How to wrap 3M 33+ Black electrical tape on wire to attach wire loom. Start by wrapping wire first. Next slip loom over wire with tape end now sticking out of loom split. Wrap three to four turns around loom and tear off tape. Wrap wire on other side then thread loom over wire again leaving tape sticking out of loom split. (see next pic) Completed splice of two seperate wire looms now joined together and wrapped in good quailty electrical tape. Completed installation of new LED Strobe lights below bumper. These lights are brighter than they appear in this photo.
