Pity7700 Build thread, why not? pic heavy!

stock set up is one fan it'll be fine.

 

I have read that these fans pull a ton of heat, maybe more than the stock fan. I will monitor it with my edge.

Yea I think that's a good idea. I might do that. I'm going to order that adjustable controller I posted for the one fan.

 

Sweet. Can't wait to see the How-To

 

Same. Ya done yet? LOL.

 

how do you mount them?

 

Jeep guys do that a lot.


Sent from my communication device using communication software

 

LOL I don't think ill have it done till next weekend. Im super busy with work. I gotta order the controller tomorrow.

You just make some brackets for it. I'm pretty sure it will mount on the mounting area fir the fan shroud . Might have to get some small brackets though.

 

Guys should I go with a probe style thermo or a radiator push in type thermo?

 

Probe type. The Push in ones have been known to work a hole into the radiator

 

alright i ordered a DERALE probe type thermo control. question is where should i stick the probe at? is there a place to put it from factory or do i have to make something to put inline with the radiator hose?

sorry i disappeared for the weekend dudes lol was out of town. i just finished fitting the fan to the radiator though. fits perfectly. i just have to make a small bracket for the passenger side mount so the fan can be bolted down. my controller should be here tuesday, i hope. i hope to have this installed this weekend. heres a few pics. i will do a full write up when im finished.



drivers side bolts right up



passenger side is a little off, need a small bracket.