Pity7700 Build thread, why not? pic heavy!

run the fan and e fans = moar powa!!!!

 

hahaha the E-fan has a motor that sticks out far on the left fan. it was sitting on the radiator fan blades while i had it sitting there. that wont work out lol plus i have to be able to get the fan shroud back on.

 

i also read how to wire both fans. one fan gets the controller with thermo. the other fan will be wired to come on with the AC. i might wire both or one of the fans with a toggle as well to turn it on when i want.

 

man that looks great! what are the size of these fans?

 

thanks Josh! I don't have exact sizes of the fans but I can measure them tonight after work and let y'all know. I will say that the whole elcetric fan assembly covers the whole radiator top to bottom.

 

thanks chris. one more thing, could you get some measurements on how much the fans stick out past the radiator. i would really be interested in knowing and would like to buy a set from you if they will fit infront of my motor.

 

no problem man. i measured the fans, the big fan is about 17" the smaller one is about 15, if i remember correctly.

i will check these measurements again but i think the fan assembly measures 30" long by 25" high (i think) the fans dont stick out past the radiator at all. they fit almost perfectly. its slightly shorter thant eh radiator length wise and about .25" shorter height wise. just had to cut some of the old mount tabs off.

i have the fan installed right now and wired it to a switch temporarily till my controller gets here on wednesday. i have just highspeed fan hooked up right now and my ECT on my edge sits between 175-182 degrees normally sits at 180 with normal fan. the fan is a little loud but again it is the highspeed fan. im pumped to get the controller and hook both of them up lol.

i will post some pics later and get you them measurments josh. im going to help my bud work on his Mustang Cobra, sick ass car. he just built a motor for it.

 

thank you! i was mainly concerned with how close they would be to the motor because i have a pulley bridge infront, but seeing as how there is room infront of the fan they should have plenty of clearance.

 

after I eat dinner I'm going to change to the low speed fan instead of the high-speed. its bigger LOL. ill measure from the front of the engine to the fans and give you a measurement.

 

thanks chris!