01f1502wd's build thread: project Stormtrooper

Googled:

For the driver headlight the dark blue/white is power for the low beam, light green/black is power for the high beam and the black is ground. For the passenger side the dark green/orange is power for the low beam, light green/black is power for the high beam and the black wire is ground.

 

^dude. again, your winning AGAIN!!!!

ok so my thoughts.....for LED headlights...

 

he's not winning he's just smart enough to use google

 

Lol I couldnt find it lol


And boom goes the dynamite.

 

OK I see the diode isolation
you planning on two sets of LED inside
each headlamp one low and one high.

 

that is correct. think it would work?

I got the idea from GM, one of their mods was to leave the low beams while the high beams are on, most put the diode on the relays them selves, but I dont want to do that, I want to have a harness that I can hook up the lights to and then plug that into my factory harness.


Joe, since you know how to work google really well....can you find me the wires in the tail lights? I have a supercrew, not sure if that would be different from the stylesides..but its not a flare side as I only have one red light and one reverse light, some flaresides have two red lights top and bottom and reverse in the middle:

 

97-99 iirc were the only ones with the middle white, red, top and bottom. I took pics before for you of the wiring harness and such.

 

so Ive got a problem. I bought some pipe mounts, theyre really for a 1.25" but my pipe is slightly smaller than that...maybe 1.125, (I cant return them that would take too long) so is there a way how I can put something on the pipe to make the mount tight? I was thinking about a foam padding or something.

 

Anyone?


And boom goes the dynamite.