I think my TRS harness is miswired from the factory.. H4 connector.. I had to swap two wires on mine, leave the ground alone and move the others around. You can make a harness or use some jump wires to test.
I think the 9004 and 9007 are the same harness but the high beam solenoid pins are different and TRS sent a bunch out that were backwards around the end of November early December
25' away from a level wall. Measure the cutoff height at your headlights, and then at the wall. The wall height should be 3" lower. and it should look like this
Ok mines only slightly off I think one side is drooping down a bit and then they just need to be close together so that the little angled parts like / are closer. You can kind of see it here on the right side.
It also looks like its rotated like mine was before I fixed it. Bring it up until the top of the cutoff meet and if its slanted then of course the projector is rotated and you'll have to either remount the projector or alter the cutoff shield inside Sent from my iPad using Tapatalk
Well since i didn't make them I dont really know how that would work ha. I can probably figure it out though I know what youre saying. If the weather is warm enough I might try today or tomorrow.
