That's the sensor I'm working with, the sensor is brand new. I'll run tests on it again just to be sure there are no open wires in the circuit.
Thanks Joe! I might just jump ahead and replace all of the vac lines in the truck. I've replaced a few vac lines and some coolant lines already.
That's what I want to do. I don't think I can rent a smoke testing unit out, that's how I remember doing it in school. Sent from my LGLS990...
No I have not. From what I've been reading, if the sensor inside the distributor was bad, the truck wouldn't even start. The truck starts and...
Alright messed around with the truck for a bit today. Got myself some new hoses for the DPFE, they were pretty rough. I did have a P0401 code...
Hahaha yea. Need to figure out this crank sensor issue. I'm sure whatever it is, it has to do with why the exhaust is smoking. Sent from my...
Hahaha I said, leta forget about it! Sent from my LGLS990 using Tapatalk
I'm an idiot. While I was letting the seafoam sit, I pulled the dash cluster out to replace the CEL bulb. In order to pull the dash trim off you...
yea no shit lol im ticked. wanted to try to clean the engine out with some seafoam and now it dont work at all. kinda odd. checked the fuel...
Mileage is shitty. Haven't driven it much before replacing the PCM . I think he truck just died though. Seafoamed the engine, thing won't start....
[IMG] Got it on, didn't fix the issue but the old coil tip was loose so it was probably needing a new one soon anyways. The rest of the ignition...
That's not good! For $50 it better work. Sent from my LGLS990 using Tapatalk
MSD ignition coil will be here at 11. I think the coil in the truck is pretty old. Found a set of numbers on it that I think could be a production...
Compression test results are in! Every cylinder but #1 had a reading of 150-160. #1 read 130 and 137. Lowest allowed reading is 128. While...
Alright, took it in a good drive let it warm up. It idles way better, still a slight stumble but no where near as bad as it was. O2 codes didn't...
Still runs a little rough, hoping the compression test will tell me something. Sent from my LGLS990 using Tapatalk
New PCM is/was plug and play!! Good news, I've got a ground signal from the PCM for the O2 heater circuit AND the light did not come on. I'll...
Me too. Should be here Tuesday. After a mail in rebate it'll be under $120. If it don't work, I'll send it back. Sent from my LGLS990 using Tapatalk
Junk yard find! Found and almost mint tail gate insert. Paid $15 for it at the U-pull. Haven't had any luck on doors or fenders yet. [ATTACH]
Yea I'm sure something would need to be upgraded. Edited my post, I meant torque not HP Sent from my LGLS990 using Tapatalk
Separate names with a comma.
