Search Results

Search Again
Page 8 of 10
  1. TunaSlayer
    Post

    TunaSlayer Mod Progress

    Next I installed 4 Hella Black Magic lights on a Smittybilt light bar. I went with the Black Magics mostly because they are smoked and match my...
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  2. TunaSlayer
    Post

    TunaSlayer Mod Progress

    SUCCESS! Did I mention it was raining and blowing 50mph for half this? Yeah, sucks [IMG] [IMG] [IMG] [IMG]
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  3. TunaSlayer
    Post

    TunaSlayer Mod Progress

    I chose to run the power off the headunit wiring harness. I've done this before and know it's safe. I like avoiding a wiring clusterfunk under the...
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  4. TunaSlayer
    Post

    TunaSlayer Mod Progress

    I found the big rubber gromet in the fire wall by the brake pedal and pushed it out from the cab side. Picked it up and drilled a hole in the...
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  5. TunaSlayer
    Post

    TunaSlayer Mod Progress

    My crimp vs theres [IMG] Both 12v red power wires for each lights to the relay all connected [IMG] Next I ran the reverse wire (white) up past the...
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  6. TunaSlayer
    Post

    TunaSlayer Mod Progress

    I bought these KC reverse lights from Quadratec (guess it's not just a Jeep thing) for $100. I know you can buy the same 'type' of lights for $20...
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  7. TunaSlayer
    Post

    TunaSlayer Mod Progress

    Finally I had found the time to go off island (yeah I live on a small island BTW) and pick up my new 20" Rockstars and 33"x12.5" Nitto Trail...
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  8. TunaSlayer
    Post

    TunaSlayer Mod Progress

    Bought a Saleen grill from the Saleen SpeedLab. Luckily they were in stock at the time. Bye bye old grill [IMG] Hello Saleen [IMG] Also had Steve...
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  9. TunaSlayer
    Post

    TunaSlayer Mod Progress

    The running boards I had painted black with getting a few chips here and there from rocks (half the roads I drive on here on the island are dirt...
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  10. TunaSlayer
    Post

    TunaSlayer Mod Progress

    Next mod was the 2" leveling kit from Autospring [IMG] [IMG] [IMG] [IMG] Before [IMG] After [IMG]
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  11. TunaSlayer
    Post

    TunaSlayer Mod Progress

    I'm a commercial fisherman and wanted a better way to transport a lot of my reels to and from the boat when tuna fishing. I had seen a lot of rod...
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  12. TunaSlayer
    Post

    TunaSlayer Mod Progress

    Thanks guys. Here's the step by step break down of the mods so far. First things first, Lightning style exhaust: Flowmaster 40 w/2 side exit tips...
    Post by: TunaSlayer, Jan 17, 2011 in forum: General Discussions
  13. TunaSlayer
    Post

    I jumped ship from F150Forum.com

    thanks guys. I'll put more detail into my build thread here then.
    Post by: TunaSlayer, Jan 17, 2011 in forum: Introduction
  14. TunaSlayer
    Media

    experimented with bed lining the FORD emblem. I like the texture, just need to spray some gloss black paint to darken it a little. Badges are alread

    Uploaded by: TunaSlayer, Jan 16, 2011, 0 comments, in album: 2007 F150 FX4 Tuna Slayer
  15. TunaSlayer
    Media

    2" Autospring level install

    Uploaded by: TunaSlayer, Jan 16, 2011, 0 comments, in album: 2007 F150 FX4 Tuna Slayer
  16. TunaSlayer
    Media

    Reverse lights installed. Wired them into the factory reverse lights and also a switch in the cab for tail gaters

    Uploaded by: TunaSlayer, Jan 16, 2011, 2 comments, in album: 2007 F150 FX4 Tuna Slayer
  17. TunaSlayer
    Media

    KC reverse lights since my tinted tail lights now blow chunks at lighting up the rear.

    Uploaded by: TunaSlayer, Jan 16, 2011, 0 comments, in album: 2007 F150 FX4 Tuna Slayer
  18. TunaSlayer
    Media

    installing the AAL

    Uploaded by: TunaSlayer, Jan 16, 2011, 0 comments, in album: 2007 F150 FX4 Tuna Slayer
  19. TunaSlayer
    Media

    converting the Hellas to 5000k HIDs

    Uploaded by: TunaSlayer, Jan 16, 2011, 1 comments, in album: 2007 F150 FX4 Tuna Slayer
  20. TunaSlayer
    Media

    custom Saleen badge from Billetbadges.com

    Uploaded by: TunaSlayer, Jan 16, 2011, 0 comments, in album: 2007 F150 FX4 Tuna Slayer
Showing results 141 to 160 of 186 Next >
Search Again
Page 8 of 10