Is this a 4x4?
I have about 4 laying around lol. I make alot of junkyard trips. Got a few good GEM's for 4x4's if you know anyone in need.
I'll post up a few more pics and a schematic whenever I get done teaching this online class today. At first I was running both batteries...
[IMG] Once you have the thermostat in, and the 0-ring in place, bolt back the top piece with the two 10mm bolts. Make sure everything is good...
Once the metal piece is out of the way, you should have easy access to the two 10mm bolts housing the thermostat. Accessing the thermostat (10mm...
With the intake out of the way, we get a view of what we need to do. I wanted to go ahead and flush the heater core and drain/flush the...
Earlier I had an issue with my enginge running slightly above normal and using up quite a bit of coolant (I used water to see if it would...
Once you have the shroud in the bottom slots, you can go ahead and screw on the fan clutch( to the right). [IMG] [IMG] Once you have the fan...
I always put the alt. belt on last because it is the smallest and easiest to get too. [IMG] Double check that the belt is put on properly and...
Re-installing Pulley Time to re-install the pulley on the pump. Use the same 4- 10mm bolts you removed earlier. Use the same leverage process...
Checking to make sure the pumps match and the O-ring is in place. Hold the old pump next to your new one to make sure they are the same one....
With the pulley off, we can now see the 4 bolts holding the water pump to the block. These 4-bolts are all 10mm and are torque down pretty...
Second: With the two bolts removed, we now need to concentrate on unscrewing the fan clutch from the water-pump. They make a tool to do this...
Draining radiator and removing hose from thermostat to radiator: Before proceeding, make sure the engine has proper time to cool, and that the...
Replacing water-pump on 5.4L 2V. Truck is a 2003 FX4 Supercab. Materials Needed: [IMG] [IMG] Water Pump with O-Ring Anti Seize & Loc -...
3) Locate the molex plug attached to the top of the hydraulic brake pedal arm. Run a small strand of 18ga wire, spliced from the (light green...
9 Pin Harness Wiring [IMG] Note: Some of these wires are optional (*6, 7, *8, 9) Wire and Function on the Harness 1) Black-Ground 2) Brown-...
Wiring :thumbup: First we will concentrate on (1) The larger gauge wires you have separated. Fused Power Constant Power Wires (The Two "Fused"...
Remote Starter- How to: For most 97-03 F150's. This one is specific for my 2003 FX4 5.4L I used the following kit from Autozone for...
The metal piece goes on the flat side on the bushing as seen below [IMG] You want to start by placing the grade 8 bushing spacer on the large...
Separate names with a comma.
