Engine block/transmission plate fitment

Discussion in 'General Discussions' started by Eastcoastitalian, Jan 31, 2017.

  1. Eastcoastitalian

    Eastcoastitalian Junior Member

    Likes Received:
    Jan 31, 2017
    Port orange Fl
    Scoured the web for the last couple days and have come up with zero definitive answers, hopefully someone here has dealt with this before and can help out. I have a 94 302 with an E40shit connected to it. Just bought a donor 88 4.9 truck with a 1990 zf 5 speed in it to replace my E40d with. I know the flywheels between the 302 and the 300 are not the same, i'm going to buy the new flywheel, slave, clutch kit, clutch master cylinder. But i really need to know if the engine plate on the back of the 300 will fit the 302?? I know the bolt pattern will line up both being the windsor bell pattern, but i'm not sure if the plate is different?? Any help is much appreciated!

Share This Page