How do I get the passenger side axle shaft out?

Doing my gear install and need help.

 

Have you ever done gears before?

 

figured it out. i just took the axle tube apart.

progress pic.


im doing this with a friend that knows how to set them up. we did my rear axle.

 

LMFAO tell me thats not the ONLY way to swap gears. That axle has to slide out without pullin the tubes off

 

It does some how. Its either got c clips or axles are bolted to tubes.

 

the front does not use C-clips like the rear. you have to take the axle tube apart because the passenger side shaft is 2 peices. the smaller piece shaft in my first pic will not allow you take out the carrier so it needs to be taken out that way. the drivers side uses a small c-clip to keep it in.

 

i still think it will come out easier

 

easier how??

 

i think theres a way to pull the axles out of the housing w/o taking the tubes off the chunk. Just doesnt make since to have to do that just to put a new axle in if you were to break one.

 

there is only one axle tube and thats for the passenger side. the shaft is two pieces so that you can disengage the axle when in 2wd.